In Reply to: Re: brake cross shaft posted by Joe Gruller on December 14, 2005 at 06:15:59:
Joe,
Yes, front motor mount is the original. Seems fine. I am not aware of rubber in motor mounts. Front or rears? Rears are bolted tight. I have not seen anything else used there. Thank- you for your response. I was leafing through a shop manual last evening and see shim plates that fit between lower frame surface and cross shaft mounts which would lower cross shaft and help but I'm not sure why it was fine before motor/trans. and rear end r&r.Thank you again.
Eric Hewitt